1991 Integra rear trailing arm bushing removal?

Thread view:

Enable EMail Alerts

Start New Thread

Thread rating:

Brian E. Clark - 20 Mar 2008 01:30 GMT

Can the "Bushing Extractor for Honda & Acura" that
seems to be all over the Internet (for example,
shoptoolsshoptools.com/shopexd.asp?id=2784) be used to
remove the remove the rear trailing arm bushings from
a *1991* Acura Integra?

Thanks.

-----------
Brian E. Clark

Reply to this Message

motsco_ - 20 Mar 2008 15:16 GMT

> Can the "Bushing Extractor for Honda & Acura" that
> seems to be all over the Internet (for example,
[quoted text clipped - 6 lines]
> -----------
> Brian E. Clark

======================

check www.tegger.com for that answer.

'Curly'

Reply to this Message

Tegger - 21 Mar 2008 02:42 GMT

motsco_ <motsco_@interbaun.com> wrote in news:13u4sbis6es46f3
@corp.supernews.com:

>> Can the "Bushing Extractor for Honda & Acura" that
>> seems to be all over the Internet (for example,
[quoted text clipped - 12 lines]
>
> 'Curly'

There is actually no answer for that on my site.

I suspect that tool is for the Civic's bushing, which is smaller than the
Integra's.

In any case, the Integra always came with rear discs, so you don't have to
break open the hydraulics to remove the trailing arm. You can therefore
remove the arm and have a garage press the old bushing out and the new one
in.

If the OP's new bushing part number is 52385-SK7-N02, then chances are
pretty good the Civic tool won't fit.

Signature

Tegger

The Unofficial Honda/Acura FAQ
www.tegger.com/hondafaq/

Reply to this Message

Rate this thread: