changed brakes and sensors - brake light still on !

Thread view:

Enable EMail Alerts

Start New Thread

Thread rating:

avinator - 10 Jun 2006 05:43 GMT

Hey Guys and Gals,

I am happy to report my break job went just fine...changed with Balo
rotors and Pagid pads all the way around and "Frauline" is very
happy...:)

The brake light is still on and I can't figure out why .. New Sensors,
new brakes and rotors and the damn thing is still on...any ideas why ?

Cheers

Avinator from Sunny CA USA

Reply to this Message

Dave Plowman (News) - 10 Jun 2006 07:24 GMT

> The brake light is still on and I can't figure out why .. New Sensors,
> new brakes and rotors and the damn thing is still on...any ideas why ?

Switch on ignition but don't start the engine and wait. If the sensors are
good and plugged in correctly it will go out and stay out.

Signature

*How about "never"? Is "never" good for you?

Dave Plowman dave@davenoise.co.uk London SW
To e-mail, change noise into sound.

Reply to this Message

avinator - 13 Jun 2006 16:34 GMT

I was able to clear the lining brake light by reseting the computer
with Peake reset tool ..

This is after I checked and rechecked the sensors twice and could not
anything wrong with the sensors....anyway thought you might like to
know for future reference..

Cheers !

> > The brake light is still on and I can't figure out why .. New Sensors,
> > new brakes and rotors and the damn thing is still on...any ideas why ?
[quoted text clipped - 7 lines]
> Dave Plowman dave@davenoise.co.uk London SW
> To e-mail, change noise into sound.

Reply to this Message