Remote Starter Install Problem

Thread view:

Enable EMail Alerts

Start New Thread

Thread rating:

GrnGyant@gmail.com - 23 Sep 2006 22:26 GMT

I was working to install a remote starter in my 95 jeep grand cherokee.
I've gotten the starter component wires hooked up, but now it seems
nothing happens. The internal electronics (locks, windows, clock) all
seem to work. But when I try to turn the key and start the car, there
is nothing. I rechecked my connections, and I could no longer get a
reading from the constant power wire in my ignition. so now I'm not
sure if the unit is even getting any power whatsoever.

Any help would be appreciated. Thanks.

Reply to this Message

MT-2500 - 23 Sep 2006 23:03 GMT

GrnGyant@gmail.com Wrote:

> I was working to install a remote starter in my 95 jeep grand cherokee.
> I've gotten the starter component wires hooked up, but now it seems
[quoted text clipped - 6 lines]
>
> Any help would be appreciated. Thanks.

If it is one of them 39$ wal mart jobs drp it in the trash can and
forget it.
If you are going to do it get a good upper end one.
The link below gives some wiring diagrams.
http://www.bulldogsecurity.com/
MT

Signature

MT-2500

http://www.automotiveforums.com

Reply to this Message

GrnGyant@gmail.com - 23 Sep 2006 23:31 GMT

> If it is one of them 39$ wal mart jobs drp it in the trash can and
> forget it.
> If you are going to do it get a good upper end one.
> The link below gives some wiring diagrams.
> http://www.bulldogsecurity.com/
> MT

Its the Bulldog RS 1300 E, that I was trying to install.

Thanks

Reply to this Message