This is my first post, though I've received a lot of help from this group
from searching old posts on Google groups.  Thank-you for that.

I pulled a V6 2.5L engine and tranny from a '93 Mazda 626 and put it in a
'94 626.  Both engines were running before I did the swap.  Now the engine I
put in the '94 will not start.  I was hoping some of you may have some ideas
of what I should try next.  Here's what I know or what I've done so far:

-the starter turns the engine with no problem
-the fuel pump is not coming on when I turn the key though I can turn it on
by jumping over it's relay
-the coil is not firing
-I can't find a check engine light on the dash
-I tried checking the codes with jumpers at the diagnostic connector both by
watching for the check engine light and with an analog meter but I see no
light and I get no voltage at all from the ECU
-tried swapping computers and tranny computers
-tried swapping ECU wire harness
-checked every ground wire I could find
-looked for pulled wires
-swapped out relays in fuse box under the hood

Any ideas?  Thanks, Benson