i own a 1991 toyota mr2 and recently its gotten really hard to switch
into gears.    back in october i had purchased a high performance
clutch in my car that grabbed very hard off firts gear.   2 months
later i couldnt switch gear it had gotten very hard so i took it in and
they told me the clucht was worn out.  so i purchased a new one and
still the same problem.  2 years ago i had encountered the same problem
but it came to be my slave and master sylinders had gone bad so i
replaced them and the car ran great.   well the mekanics told me the
the sylinders were bad again because   the high performance clutch i
had installed in october was too much  and they were shot again.  so i
replaced the cylinders again put in a new flywheel because the old one
was wore out bought new motor mounts all around even changed the cables
that run from the shifter to the transmission, and still the same
problem. the only time im able to switch gears some wat ok is wen the
car is moving.   im about to purchase a new pressure plate from the
dealer because they tell me that might be the problem too.  but the
pressure plate it has on there has les than ten miles on it.  i dont
know wat else to do.  im running out of options.    heeeelp.