Home | Contact Us | FAQ | Search & Site Map | Link to Us
Sign In | Join | Other 45 Sites in Network
HomeAnnouncements
Discussion Groups
By Brand
BMWChevroletDodgeFordGMHondaLexusMercedes-BenzNissanPeugeotToyotaVolkswagenOther Brands
By Topic
4x4 CarsRVsDrivingMaintenance & RepairCar AudioCollectible Cars
Country Specific
Australian ForumsUK Forums
ArticlesAuto InsuranceBuyingCars & TechnologyMaintenanceMiscellaneousSafety
DMV Resources
Related Topics
MotorcyclesBoatsMore Topics ...

Car Forum / Driving, Maintenance, Tuning / General Car Topics / April 2007

Tip: Looking for answers? Try searching our database.

car will turn over but tha is all

Thread view: 
Enable EMail Alerts  Start New Thread
Thread rating: 
mdm68@excite.com - 01 Apr 2007 19:39 GMT
I have a 2000 chevy blazer ,on Fri It would not turn over but not go
seems like no gas was getting to the motor we checked the fuel pump
and it turns on ,We put on a new fuel filter and air filter and it
seemed to wrk til the am It did the same thing what else could it be
Please help
MiltRuiz506@hotmail.com - 24 Apr 2007 02:57 GMT
On Apr 1, 11:39 am, m...@excite.com wrote:
> I have a 2000 chevy blazer ,on Fri It would not turn over but not go
> seems like no gas was getting to the motor we checked the fuel pump
> and it turns on ,We put on a new fuel filter and air filter and it
> seemed to wrk til the am It did the same thing what else could it be
> Please help

You need three things to start a car:  Fuel, Spark, and Compression.
Your engine turns over, and you have fuel, so that's a good start, now
take one of your spark plugs out, cover the hole with something, and
ground the spark plug.  Turn the ignition switch and check to see if
there is spark.  If not, there is something wrong with your ignition
system.  I would replace the wires, plugs, distributor cap and rotor
first.  Troubleshooting from there is a real pain....  I had a bad
igintion module (little part inside the distributor) once, so I tend
to look at them as inherently suspicios; but the pickup coil is
another likely suspect.  If you have a system that has a separate coil
for each cylinder be very careful, as the voltage is very high on
those.  I probably wouldn't try to service something like that without
a shop manual...
 
Sign In
Join
My Latest Posts
My Monitored Threads
My Blog
My Photo Gallery
My Profile
My Homepage

Start New Thread
Enable EMail Alerts
Rate this Thread



©2008 Advenet LLC   Privacy Policy - Terms of Use
This website includes both content owned or controlled by Advenet as well as content owned or controlled by third parties.