fuel pressure gauge?

Thread view:

Enable EMail Alerts

Start New Thread

Thread rating:

Greg - 13 Jun 2005 19:08 GMT

i am in the process of putting a ATI procharger on a 87, it shipped
today. i want some instrumentation for the car, i have purchased a
"innovate" LM-1, LMA-3, and the Gauge that goes with this wide band
air/fuel ratio meter, also i have Autometer boost and electric fuel
pressure gauges. The question is does any one make a adaptor that will
screw on to the stock fuel pressure test port that i can convert to
1/8 NPT? i am not having much luck finding anything. you would think
as many TPI motor as there are out there some one would make one.
if not i guess it is off to the machine shop. thanks, Greg

Reply to this Message

greg nettles - 15 Jun 2005 02:51 GMT

nobody has put a fuel pressure gauge on a tpi motor?

>i am in the process of putting a ATI procharger on a 87, it shipped
>today. i want some instrumentation for the car, i have purchased a
[quoted text clipped - 5 lines]
>as many TPI motor as there are out there some one would make one.
>if not i guess it is off to the machine shop. thanks, Greg

Reply to this Message

Greg - 18 Jun 2005 20:16 GMT

Machine shop should have my adaptor done by Tuesday, the thread size
where it goes into the fuel log is 5/16-18 and will seal with a flat
seal ring with a rubber o-ring made to it, making it out of stainless
(308) it will have a hex head and then will neck up to a AN -04 male.
i still can not belive that no one makes something like that.
Greg

Reply to this Message