Rear Spindle / Bearing Tools

Rear Spindle / Bearing Tools - Used

Thread view:

Enable EMail Alerts

Start New Thread

Thread rating:

Koilmaker - 08 Aug 2007 04:15 GMT

I would like to purchase used tools to rebuild my 72 Vette rear
spindles. I am looking for al of them - bushing flaring tool, spindle
setup tool, etc.

Please email me if you have any C3 Corvette specialty tools for sale -
used only

Thank You

Reply to this Message

Tom in Missouri - 08 Aug 2007 15:05 GMT

You can find these frequently on eBay. Also, if you join a local club, the
local club often buys tools for the club that are a one-time use for the
average member.

Plus you frequently get help from other members who have used them and have
done the job before.

>I would like to purchase used tools to rebuild my 72 Vette rear
> spindles. I am looking for al of them - bushing flaring tool, spindle
[quoted text clipped - 4 lines]
>
> Thank You

Reply to this Message

Bob G. - 11 Aug 2007 12:03 GMT

>You can find these frequently on eBay. Also, if you join a local club, the
>local club often buys tools for the club that are a one-time use for the
>average member.
>
>Plus you frequently get help from other members who have used them and have
>done the job before.

As Tom says there are many reasons for joing and being active in a
Local Corvette Club... I belong to two Clubs, and neither owns any
tools BUT the indivual members sure do and I have found loaning tools
to be quite common..and usually you can find all the technical help
from someone...

I am a lifetime member of the C3 Registry (www.C3VR.com) and if you
want info thats a very good source.. Never saw many tools for sale
however but then again I never check the for sale forums...

Lots of luck
Bob G.
64 72 & 98 Convertibles
76 & 79 Coupes
.

Reply to this Message