turn-signal

Thread view:

Enable EMail Alerts

Start New Thread

Thread rating:

bearkatdrummer - 18 Jun 2006 02:56 GMT

My brake lights went out(91 C/K 1500), which i figured out by my fast
blinker, and after i replaced the brakelights, the turn signal on the
right rear still wont work. I used the correct double contact bulbs,
and the front signal still works, as well as the brake lights, but the
blinker still wont function on that side. What do I do?

Reply to this Message

ronlin79 - 18 Jun 2006 04:01 GMT

I don't know if this is also true on a 91. My 89 had flat metallic
straps running to the lamps. One of the straps had rusted through. I
solved it by soldering copper braid accross the gap.

> My brake lights went out(91 C/K 1500), which i figured out by my fast
> blinker, and after i replaced the brakelights, the turn signal on the
> right rear still wont work. I used the correct double contact bulbs,
> and the front signal still works, as well as the brake lights, but the
> blinker still wont function on that side. What do I do?

Reply to this Message

Frank S. - 18 Jun 2006 21:08 GMT

Check the grounds. You might have to "add" a ground to the light socket.
Frank

>My brake lights went out(91 C/K 1500), which i figured out by my fast
>blinker, and after i replaced the brakelights, the turn signal on the
[quoted text clipped - 3 lines]
>
>

Reply to this Message

Michael McNeil - 31 Jul 2006 10:19 GMT

The circuit board itself might now be faulty. I thought this was the case in my L/R light problem
but as it turned out it was a break in one of the wires inside the wire loom which was the culprit.

>My brake lights went out(91 C/K 1500), which i figured out by my fast
>blinker, and after i replaced the brakelights, the turn signal on the
>right rear still wont work. I used the correct double contact bulbs,
>and the front signal still works, as well as the brake lights, but the
>blinker still wont function on that side. What do I do?

Reply to this Message