Removal Procedure

For information on stoplamp circuit diagnosis, refer to Lighting Systems
in Body and Chassis; and Electrical Diagnosis.

      Caution

      Before servicing any electrical component, the ignition key must
be in the OFF or LOCK position and all electrical loads must be OFF,
unless instructed otherwise in these procedures. If a tool or equipment
could easily come in contact with a live exposed electrical terminal,
also disconnect the negative battery cable. Failure to follow these
precautions may cause personal injury and/or damage to the vehicle or
its components.
   1. Disconnect the negative battery cable.
   2. Disable the SIR. Refer to Disabling the SIR System in SIR.
   3. Remove the pushrod retainer from the brake pedal pin. Use snap
ring pliers.
   4. Unsnap the stoplamp switch from the pushrod.
   5. Disconnect the electrical connector from the stoplamp switch.

Installation Procedure

   1. Connect the electrical connector to the stoplamp switch.
   2. Snap the stoplamp switch onto the pushrod.
   3. Install the pushrod retainer on the brake pedal pin. Use an 11 mm
(7/16 in) socket in order to push a new clip onto the pin.
   4. Connect the negative battery cable.
   5. Enable the SIR. Refer to Enabling the SIR System in SIR.

screwdriver and/or cotter pin puller.