Power windows and locks

Thread view:

Enable EMail Alerts

Start New Thread

Thread rating:

Doug - 22 Jan 2005 03:54 GMT

I have a 1994 Silverado 4x4. The drivers window will not move.The passenger
is fine.(power windows and locks).

It has been 8 below 0 the past few days.I am hoping it is frozen.
My question is the panel that surround the window and door lock controls.I
do not see no screws,does this panel just un snap or clip off???

Also my auto door locks has a problem.Passenger and drivers side both
open.The passenger side unlocks fine.The drivers side only goes down when
locking 1/2 way.Would this be the actuator??

Thanks
Doug

Reply to this Message

Rufus T. Firefly - 22 Jan 2005 06:34 GMT

You might have to pop off an escutcheon or two to reveal any screws,
and also check on the bottom.
Once the screws are out, the panel should be held on only by clips.

> I have a 1994 Silverado 4x4. The drivers window will not move.The passenger
> is fine.(power windows and locks).
[quoted text clipped - 9 lines]
> Thanks
> Doug

Reply to this Message

Doug - 23 Jan 2005 03:01 GMT

Thanks.

I put my truck in a friends garage overnight with a heater.The window is
working fine.Must of been frozen!!!

Warmed up to 4 degrees today.

Doug

> You might have to pop off an escutcheon or two to reveal any screws,
> and also check on the bottom.
[quoted text clipped - 15 lines]
>> Thanks
>> Doug

Reply to this Message