96 Town & Country Oxygen Sensor

Thread view:

Enable EMail Alerts

Start New Thread

Thread rating:

techdrive - 21 Oct 2004 23:39 GMT

I need to change my upper (manifold) O2 sensor and I can just see it from
under the vehicle way up on top of the rear manifold. Anyone have any
proceedures for getting to it? It looks like I need to drop the engine or
something drastic like that to get to it. Help!

Reply to this Message

maxpower - 21 Oct 2004 23:43 GMT

Before dropping the engine......take it to a shop and ask them to get it
off, its easier to raise the vehicle then pull the engine
Glenn Beasley
Chrysler Tech

> I need to change my upper (manifold) O2 sensor and I can just see it from
> under the vehicle way up on top of the rear manifold. Anyone have any
> proceedures for getting to it? It looks like I need to drop the engine or
> something drastic like that to get to it. Help!

Reply to this Message

techdrive - 22 Oct 2004 00:56 GMT

Do you know a proceedure? I was hoping to keep out of the shop if possible
sparing funds. Thanks

Reply to this Message

maxpower - 22 Oct 2004 01:01 GMT

well you never did say what engine it has?? if its the 3.3/3.8 with a
specail wrench you may be able to get it from the top,

> Do you know a proceedure? I was hoping to keep out of the shop if possible
> sparing funds. Thanks

Reply to this Message

techdrive - 22 Oct 2004 01:58 GMT

Thanks, It is the 3.8, forgot to mention that.

Reply to this Message

mic canic - 23 Oct 2004 21:11 GMT

if you have a new one then cut the wires off at the sensor so u can use
a regular socket to remove it from underneath just jack it up

> Thanks, It is the 3.8, forgot to mention that.

Reply to this Message