Hi Young,
I have a '96 neon with a similar problem. My speedo just stopped working
one day on the highway. I found out that there is an intermittancy in the
dash board. When the speedo stops working, all I have to do is slap the
dash and it works again. I think there is a cold solder joint in the dash
module that causes this problem. Everytime this happens. all I do is slap
the damn dash and it works every time.
As far as your engine cutting out, I have no idea. sorry. But I don't
think the two problems are related.
> Hi all,
>
[quoted text clipped - 11 lines]
>
> Thanks
>Hi all,
>
[quoted text clipped - 3 lines]
>engine would cut out completely.
>Any ideas what's going on?
What Year.
A symptom of the power managemanet computer failing sometimes effect
the speedo.
It may be covered under the emmission warranty so make sure you ask.
I had a Omni once that had the same problem and the dealer was going
to charge me for a new computer till I told them it should be covered
under that warranty and it was.
Daniel J. Stern - 29 Mar 2005 22:05 GMT
> >Last night as I drove back from work I noticed my speedometer behaving
> >erratically and then it stopped working completely. Then this morning
> >as I drove to work I found that as I shifted down from third to second
> >the car engine would cut out completely. Any ideas what's going on?
> A symptom of the power managemanet computer failing sometimes effect
> the speedo.
Chrysler engine computers almost never fail, and the original poster's
problem is probably nothing more severe than a faulty vehicle speed
sensor.
maxpower - 30 Mar 2005 00:31 GMT
> >Hi all,
> >
[quoted text clipped - 14 lines]
> to charge me for a new computer till I told them it should be covered
> under that warranty and it was.
Could be a speed sensor, if the vehicle has cruise control does it work??
and when the car cuts off does it start right back up??
Glenn Beasley
Chrysler Tech