99'T&C no cruise and airbag light stays on

Thread view:

Enable EMail Alerts

Start New Thread

Thread rating:

Frank Boettcher - 28 Jun 2005 14:02 GMT

On my 1999 T & C 3.8L the cruise control stopped working, (the cruise
control on/off switch will not get a cruise on indication on the dash
panel) within a few hours of that happening, the airbag light came on
and stayed on.

Brakes light switch seems to be working, and I am getting no
diagnostic code indication when I go through the cycle to get the
blinking light indication.

No fuses seem to be bad.

Any theories? Could the two be related? Would it be worth it to pull
the steering wheel air bag module and look for something electrical
wrong inside? My all but useless Haynes manual is especially useless
in the area of Airbag diagnostics.

Thanks in advance.

Frank

Reply to this Message

kmatheson@sisna.com - 28 Jun 2005 15:22 GMT

Sounds like a classic case of a bad clock spring. The clock spring
provides the electrical connections for the column air bag, and the
cruise control switches. I believe there was a recall for this.

-Kirk Matheson

Reply to this Message

TNKEV - 28 Jun 2005 16:21 GMT

call your local dealer Frank and give them your VIN number,there is a
recall out for that and your vehicle may apply. that recall if it
applies to you, is a warranty(free) recall for the life of the
vehicle.

Reply to this Message

Frank Boettcher - 28 Jun 2005 18:12 GMT

Thanks, Gentlemen, for the advice. I went to the files and found the
clockspring recall letter. (mine fell into the category, higher
mileage, fix only on failure). I've made an appointment at the dealer
to have it replaced.

Your posts kept me from doing something rash that I would have surely
regretted.

Frank

>call your local dealer Frank and give them your VIN number,there is a
>recall out for that and your vehicle may apply. that recall if it
>applies to you, is a warranty(free) recall for the life of the
>vehicle.

Reply to this Message