> THIS IS A PUZZLER TO ME, MY 2002 TOWN & COUNTRY VAN WILL START 1/2 OF THE
> TIME AND START BUT SHUT OFF AFTER 2 SECONDS THE REST. AFTER THE 4TH TRY IT
[quoted text clipped - 5 lines]
> THANKS TO ANYONE WITH SOME INPUT.
> KELSEY
Turn off the caps!!! No need to yell
Your vehicle has a sentry key problem or the Immobilizer is not receiving
the proper info from the key.
More then likely there is a fault code set in the SKIM module. Take it to
the dealer or someone that has a scanner and is familiar with the system.
The system is designed to lock out any other attempts at starting the
vehicle after the 3rd try. It wont crank at all. And after the fourth try
it actually takes an hour to reset itself.
If you have one of those Mobil Key Passes on your key ring, this could cause
these exact symptoms, It will interfere with the system.
Glenn Beasley
Chrysler Tech
Mr.X - 08 Nov 2005 00:35 GMT
>> THIS IS A PUZZLER TO ME, MY 2002 TOWN & COUNTRY VAN WILL START 1/2 OF THE
>> TIME AND START BUT SHUT OFF AFTER 2 SECONDS THE REST. AFTER THE 4TH TRY
[quoted text clipped - 23 lines]
>Glenn Beasley
>Chrysler Tech
Question for Glenn or others
If someday I wanted to have the SKIS disabled, is that possible?
if I had the DRB3 could that just disable the SKIS/SKIM or is the
PCM configured such that once SKIM is enabled there is no way to
disable it on that particular PCM ( even with the correct PIN code )
and it can only be disabled or not enabled with a NEW / Replacement
PCM
thanks just interested.
also for those interested complete data on the remote devolped by TRW
can be found by the FCC data ID a small part follows
Automotive Electronics Group
2001 JRlKJ RKE Transmitter
Principles of Circuit Operation
The transmitter utilizes a SAW resonator controlled oscillator to
generate a carrier of frequency of
315.0 MHz.. When a button is pressed, a Keeloq encoder will generate
an associated encrypted
command code; the code will be modulated onto the 315 MHz. carrier by
means of ASK
modulation; the modulated RF carrier then will be radiated through the
onboard antenna.
The transmitter will enter sleep mode after the pressed button is
released or after a button is
pressed down for about 27.5 seconds, whichever comes first. The Keeloq
encoder updates the
content of coding for each time of transmitting with a specific
encryption key.
maxpower - 08 Nov 2005 09:19 GMT
> >> THIS IS A PUZZLER TO ME, MY 2002 TOWN & COUNTRY VAN WILL START 1/2 OF THE
> >> TIME AND START BUT SHUT OFF AFTER 2 SECONDS THE REST. AFTER THE 4TH TRY
[quoted text clipped - 55 lines]
> content of coding for each time of transmitting with a specific
> encryption key.
I don't believe you can remove it from the system. The DRB does not have the
option to turn it off or disable it. Even by replacing the PCM it will try
to communicate with the skim module. If you remove the skim module it will
not start . The only possible way I could think of would be replacing the
BCM and PCM (that's is not equipped with skim) and leaving the skim
disconnected, But that would be foolish to try unless you were planning on
stealing the vehicle. Make friends with the one on your vehicle because I
think it is there to stay.
Glenn Beasley
Chrysler Tech
KB02town&country - 08 Nov 2005 04:56 GMT
Thank you for your knowledge! It is at a Chrystler dealership as we speek,
we thank you so much, my husband says that the tech there mentioned the skim
module and the relays, why he didn't fix it last time I don't know. I have
owned this vehicle for 1 month and been able to drive it only for non stop
drives and have even had it towed only to get it home and start it!! Again
we appreciate your help and answer.
>> THIS IS A PUZZLER TO ME, MY 2002 TOWN & COUNTRY VAN WILL START 1/2 OF THE
>> TIME AND START BUT SHUT OFF AFTER 2 SECONDS THE REST. AFTER THE 4TH TRY IT
[quoted text clipped - 15 lines]
>Glenn Beasley
>Chrysler Tech