Ignition Lock Cylinder removal?

Thread view:

Enable EMail Alerts

Start New Thread

Thread rating:

jmcgill - 03 May 2006 19:20 GMT

I need to remove the ignition lock cylinder on my 1988 Aries. Can
anyone out there tell me what's involved with doing this? Is there
some trick to it, or do I have to take the steering wheel off and
remove all the innards?

Thanks,

Joe

Reply to this Message

Joe Pfeiffer - 03 May 2006 20:17 GMT

> I need to remove the ignition lock cylinder on my 1988 Aries. Can
> anyone out there tell me what's involved with doing this? Is there
> some trick to it, or do I have to take the steering wheel off and
> remove all the innards?

Remove steering wheel, dig from there. Have an FSM handy, and it's
not a bad idea to take photos as you go.

Signature

Joseph J. Pfeiffer, Jr., Ph.D. Phone -- (505) 646-1605
Department of Computer Science FAX -- (505) 646-1002
New Mexico State University http://www.cs.nmsu.edu/~pfeiffer

Reply to this Message

aarcuda69062 - 03 May 2006 20:37 GMT

In article
<1146680445.882570.17610@u72g2000cwu.googlegroups.com>,

> I need to remove the ignition lock cylinder on my 1988 Aries. Can
> anyone out there tell me what's involved with doing this? Is there
[quoted text clipped - 4 lines]
>
> Joe

Steering wheel has to come off, lock plate has to come off, turn
signal switch has to come out a ways...

Reply to this Message