'97 Chrysler Sebring Convertible - no power to code reader DLC pin 16 ?

Thread view:

Enable EMail Alerts

Start New Thread

Thread rating:

Gene - 29 Jul 2007 15:36 GMT

Vehicle:
1997 Chrysler Sebring Convertible JXI
2.5L,V6, Gas, FI, VIN "H", EEB, JXI

I purchased a new code scanner (OBD II).
I connected the scanner to the DLC connector
under the dash.
There is no power to pin 16.
I tested pin 16 (+), and pin 4 (- and ground) of the DLC
and the is NO power to pin 16.
I do not have a wiring diagram that shows the pin-out
connectors to/from the DLC.

What is the procedure to determine why the DLC pin 16
lacks at least 8VDC?

THANKS,
Gene

Reply to this Message

bllsht - 29 Jul 2007 21:32 GMT

>Vehicle:
>1997 Chrysler Sebring Convertible JXI
[quoted text clipped - 14 lines]
>THANKS,
>Gene

1. Check fuses
2. Get wiring diagram and get dirty.

Reply to this Message

damnnickname - 30 Jul 2007 00:58 GMT

Pin 16 is fused B(+) Located in the junction block. Fuse #5 10 amp (red)
The procedure is to first check all fuses

Glenn Beasley
Chrysler Tech

Reply to this Message

philthy - 31 Jul 2007 03:52 GMT

replace all blopwn fuses in the pdc and the fuse box inside the car

> Vehicle:
> 1997 Chrysler Sebring Convertible JXI
[quoted text clipped - 14 lines]
> THANKS,
> Gene

Reply to this Message

Gene - 31 Jul 2007 04:59 GMT

THANKS all !!!

It was a blown Fuse 10A fuse #5.
I guess the Amp under the passengers side went out.

The new OBD II reported all OK.

Thanks for the help.

Gene

> Vehicle:
> 1997 Chrysler Sebring Convertible JXI 2.5L,V6, Gas, FI, VIN "H", EEB, JXI
[quoted text clipped - 13 lines]
> THANKS,
> Gene

Reply to this Message