2000 voyager : How to check codes without scan tool?

Thread view:

Enable EMail Alerts

Start New Thread

Thread rating:

Woodsy - 05 Dec 2007 20:43 GMT

I have tried the on/off, on/off, on/off trick = nothing

I held the trip and rest buttons in during power on and the van went
into a diagnostic:

Code 999
Check 1
Check 2
Check 3

But, still no P codes.

What am I doing wrong?

Reply to this Message

Mike - 05 Dec 2007 22:52 GMT

>I have tried the on/off, on/off, on/off trick = nothing
>
[quoted text clipped - 9 lines]
>
> What am I doing wrong?

You got it backwards, try off/on, off/on, off/on.

Reply to this Message

Woodsy - 06 Dec 2007 14:10 GMT

> >I have tried the on/off, on/off, on/off trick = nothing
>
[quoted text clipped - 11 lines]
>
> You got it backwards, try off/on, off/on, off/on.

Thanks for getting back to me. I tried the sequence exactly as you
described, still nothing even after waiting 30 seconds.

so, I have another question:
From off to the first on position, the odometer shows and gear shift
location show.
The second position ; the dash board "boots" up with bells ringing
ect.
The third position: is the starter.

From off to what (on) position should I be trying?

I did try the sequence from off to position 1 and off to position 2
the results were the same. nothing.

The check engine light only comes on when van is running... Is that
the problem? seems like I should still see P code 55 if there was
nothing to report...
thanks for the help,

Reply to this Message

Bob Shuman - 07 Dec 2007 00:03 GMT

The on/off/on/off/on procedure does not work with that year and make of
vehicle. You will need to have the error code read to find out why the CEL
is lit. AutoZone will read it for free if you have one near where you live.

Bob

> Thanks for getting back to me. I tried the sequence exactly as you
> described, still nothing even after waiting 30 seconds.
[quoted text clipped - 15 lines]
> nothing to report...
> thanks for the help,

Reply to this Message

Mike - 07 Dec 2007 05:38 GMT

>> >I have tried the on/off, on/off, on/off trick = nothing
>>
[quoted text clipped - 31 lines]
> nothing to report...
> thanks for the help,

You want to go from "off" to "on" (what you are calling the second position)
3time within 5 seconds total time. off/on, off/on, off/on I'm not that
familiar with Dodge but on Jeeps you can do the same thing, except on Jeeps
there were a few years were the key cycling would not work. It may be the same
with Dodge.

Reply to this Message

philthy - 08 Dec 2007 16:36 GMT

turn the key off annd on 3 times and watch the odometer
i was thinking 2000 was when they allowed it again in the controller

> >I have tried the on/off, on/off, on/off trick = nothing
> >
[quoted text clipped - 11 lines]
>
> You got it backwards, try off/on, off/on, off/on.

Reply to this Message