Dash light bulbs

Thread view:

Enable EMail Alerts

Start New Thread

Thread rating:

FMB - 12 Oct 2006 04:36 GMT

'03 2500 CTD Laramie

One dash light bulb went out. It was behind the 70MPH area. I ordered two
bulbs so I would have one spare. I replaced the dead bulb and put
everything back together. Night time came, I tried it and lo and behold, a
different bulb was out, this time behind the 3K RPM area. Next morning, I
opened things up and checked to see if I knocked it loose, I didn't, it was
burnt out. I put my spare in there.

Next night, I checked the lights again and a third bulb is now out,
somewhere around 5K RPM area (not that I ever go that fast). The bulbs I
pulled out had purple bases, the replacements have black bases and appear to
be the same brightness.

Did the dealer give me the right bulbs? I still have the bag and the "PICK"
paper but don't see which of the numbers might be the part number. I'm
thinking it is 1174H8N80 BULB. I don't have the receipt any longer.

Should I replace all the bulbs in the dash one at a time, or all at once so
I don't wear out the instrument panel screws? What is next, overhead
interior lights? Headlights? turnsignals? running lights? Or is it just my
luck?

FMB
(North Mexico)

Reply to this Message

Joe Brophy - 12 Oct 2006 13:21 GMT

>'03 2500 CTD Laramie
>
[quoted text clipped - 21 lines]
>FMB
>(North Mexico)

With incandescent type bulbs as they burn the filaments start to not only get
smaller since they are emitting small particles of themselves as they glow, but
also the filaments become brittle as well. IMHO, if the bulbs have been in use
for a few years since new I would replace them as a group while you've got the
access to the dash opened. It doesn't take much of a shock to break or at least
crack a filament in a used bulb. If cracked it will likely burn out the next
time it is powered on due to the initial surge of current it gets as it warms to
operating temperature anyway.

A more reliable alternative would be to find LED replacements for the type bulb
that is used in your application. Initial cost is higher but you shouldn't have
to replace any of these bulbs for the remaining life of the vehicle. You
should be able to find compatible LED replacement bulbs in white, blue and
perhaps other colors that can be used for added effect on the backlighting of
the dash. regards, Joe.

Reply to this Message