1. DRILL PRESS: A tall upright machine useful for suddenly snatching
flat metal bar stock out of your hands so that it smacks you in the chest
and flings your beer across the room, splattering it against that freshly
painted part you were drying.

     2. WIRE WHEEL: Cleans paint off bolts and then throws them somewhere
under the workbench with the speed of light. Also removes fingerprint whorls
and hard-earned guitar calluses in about the time it takes you to say,
"sh.t!!!"

     3. ELECTRIC HAND DRILL: Normally used for spinning pop rivets in their
holes until you die of old age.

     4. PLIERS: Used to round off hexagonal bolt heads.

     5. HACKSAW: One of a family of cutting tools built on the Ouija board
principle: It transforms human energy into a crooked, unpredictable motion,
and the more you attempt to influence its course, the more dismal your
future becomes.

     6. Vice GRIP PLIERS: Used to round off bolt heads. If nothing else is
available, they can also be used to transfer intense welding heat to the
palm of your hand.

     7. OXYACETYLENE TORCH: Used almost entirely for setting various
flammable objects in your w/shop on fire. Also handy for igniting the grease
inside a wheel hub you're trying to get the bearing race out of.

     8. WHITWORTH SOCKETS: Once used for working on older British cars and
motorcycles, they are now used mainly for impersonating that 9/16 or 1/2"
socket you've been searching for the last 15 minutes.

     9. HYDRAULIC FLOOR JACK: Used for lowering an automobile to the ground
after you have installed your new disk brake pads, trapping the jack handle
firmly under the bumper.

     10. EIGHT-FOOT LONG DOUGLAS FIR 4X4: Used to attempt to lever an
automobile upward off a hydraulic jack handle.

     11. TWEEZERS: A tool for removing splinters of wood, especially
Douglas fir.

     12. TELEPHONE: Tool for calling your neighbour to see if he has
another hydraulic floor jack.

     13. SNAP-ON GASKET SCRAPER: Theoretically useful as a sandwich tool
for spreading mayonnaise; used mainly for removing dog faeces from your
boots.

     14. E-Z OUT BOLT AND STUD EXTRACTOR: A tool that snaps off in bolt
holes and is ten times harder than any known drill bit.

     15. TWO-TON HYDRAULIC ENGINE HOIST: A handy tool for testing the
tensile strength of bolts and fuel lines you forgot to disconnect.

     16. CRAFTSMAN 1/2 x 16-INCH SCREWDRIVER: A large motor mount prying
tool that inexplicably has an accurately machined screwdriver tip on the end
without the handle.

     17. AVIATION METAL SNIPS: See hacksaw.

     18. TROUBLE LIGHT: The home builder's own tanning booth. Sometimes
called drop light, it is a good source of vitamin D, "the sunshine vitamin,"
which is not otherwise found under cars at night. Health benefits aside, its
main purpose is to consume 40-watt light bulbs at about the same rate that
105-mm howitzer shells might be used during, say, the first few hours of the
Battle of the Bulge. More often dark than light, its name is somewhat
misleading.

     19. PHILLIPS SCREWDRIVER: Normally used to stab the lids of old-style
paper-and-tin oil cans and squirt oil on your shirt; can also be used, as
the name implies, to round off the interiors of Phillips screw heads.

     20. AIR COMPRESSOR: A machine that takes energy produced in a
coal-burning power plant 200 km away and transforms it into compressed
air that travels by hose to an Pneumatic impact wrench that grips rusty
bolts last tightened 70 years ago by someone at GM, and rounds them off or
twists them off.

     21. PRY BAR: A tool used to crumple the metal surrounding that clip or
bracket you needed to remove in order to replace a 50 cent part.

     22. HOSE CUTTER: A tool used to cut hoses 2 cm too short.

     23. HAMMER: Originally employed as a weapon of war, the hammer
nowadays is used as a kind of divining rod to locate expensive parts not far
from the object we are trying to hit.

     24. MECHANIC'S KNIFE: Used to open and slice through the contents of
cardboard cartons delivered to your front door; works particularly well on
boxes containing upholstered items, chrome-plated metal, plastic parts and
the other hand not holding the knife.

     So there you have it: a complete description of the tools all men
need, and occasionally use correctly.