I just had the thermostat replaced but it still not blowing hot air.
Apparently they also changed the gasket and they flushed it. Any ideas of
what else could be wrong??
> I just had the thermostat replaced but it still not blowing hot air.
> Apparently they also changed the gasket and they flushed it. Any ideas of
> what else could be wrong??
Sure, if the hoses going into the firewall are hot going in and cold going
out and the coolant system is full.........your heater core is stopped up
Glenn Beasley
Chrysler Tech
o2pz5y402@sneakemail.com - 31 Oct 2005 15:48 GMT
you can backflush it by disconnecting hoses and running water thru it
in the opposite direction of normal flow.if both hoses are hot then
check inside car for blower system vent doors control failure.they are
either vacumn or wire controled.was it working previously?