The information in this post as incorrect. What is needed is an AC
"Kit"....whatever that may consist of. It is the "kit" that will cost $1000
including labor. Is this a fair price?
> Hi, all. I have quick question that I'm hoping someone here can answer. My
> AC stopped blowing cold air and I took it in to be looked at. I was told
[quoted text clipped - 7 lines]
>
> AZBRONCOGUY
>AZ Bronco Guy wrote:
>It is the "kit" that will cost $1000
[quoted text clipped - 3 lines]
>>Is it something that a not-so-mechanical-person could do on their own?
>> AZBRONCOGUY
Since your say your shop states there is a leak coming from the
compressor (or did you mean Condenser?), it sounds to me like they might want
to install a reseal kit in it, however I would have to recommend a rebuilt
compressor from a parts store because it will cost about the same price as
installing a seal kit in the old unit with the labor involved.
Although I suspect that there is more to this repair than is being stated
by you or the garage as a Condenser or an evaporator Core are also popular
items to replace on these models. To save time some garages don't always
state every move they are going to make, they state the major problem and say
"We can fix it for about a thousand" -J
>>Is it something that a not-so-mechanical-person could do on their own?
Do you know how to replace the parts mentioned or how to evacuate and
recharge an A/C system?
AZ Bronco Guy - 23 May 2006 05:39 GMT
Thereby you are saying that the expense could go even higher?
> >AZ Bronco Guy wrote:
> >It is the "kit" that will cost $1000
[quoted text clipped - 21 lines]
> Do you know how to replace the parts mentioned or how to evacuate and
> recharge an A/C system?
Wrench007 - 23 May 2006 05:53 GMT
>Thereby you are saying that the expense could go even higher?
There is always that variable, but if this is a garage you know of being
reputable their rough estimate usually covers the repair cost. If the repair
cost is lower you are all the more a happy customer. -J
steve - 02 Jun 2006 01:31 GMT
> >Thereby you are saying that the expense could go even higher?
> >
[quoted text clipped - 5 lines]
> Message posted via CarKB.com
> http://www.carkb.com/Uwe/Forums.aspx/dodge/200605/1
FYI: If anyone sees that there is a lack of pressure coming out when
the fan is on high, check first to see if the evaporator is plugged.
This occurrs due to the fact that it is position behind the firewall
under the shroud of the hood. When dirt and leaves collect there, they
break down and collect on the evaporator fins just like your radiator.
The cure: a good degreaser, let it sit for a while and then clean it
out with a pressure washer. May be a little tricky to get at, but it'll
save you further problems and getting dinged at the garage!!
Steve
AZ Bronco Guy - 26 Jul 2006 05:55 GMT
I bought 3 cans of refrigerant with a sealer and filled the vehicle up. I
didn't detect any leaks around the compressor but did find that a junction
box mounted to the dashboard was covered with refrigerant. I suppose this is
wear the leak is but I have been running the AC in the van for over a week
now and I have checked the level a few times. It doesn't seem to be leaking
now. Wondering if the sealer worked? What is this "junction box"? Would the
box need to be replaced or just the o-rings replaced in the box? Any
suggestions?
Spence
>> >Thereby you are saying that the expense could go even higher?
>> >
[quoted text clipped - 17 lines]
>
> Steve