Hi, I have a 2002 Mountaineer (Explorer) which I bought new with the
Class III/IV Factory Tow package. I want to install an electronic brake
controler for electric trailer brakes. When I bought the car, they gave
me a plastic bag with the pigtail connector and a sheet with a wiring
diagram and sketch showing the pre-installed connector on the vehicle.
According to the sheet  "a factory installed 6-way gray connector is
located under the instrument panel on the drive side." A caption on the
picture with an arrow pointing to the connector says "6-way gray
connector located on forward edge of instrument panel (1L2T-14401)

I've just spent about two hours under the dash and can't find the
connector. There are no open connectors, except a large green one with
aboout 8 or 10 wires coming out of it mounted on a metal cross bar and
the OBD connector, and in any event, the green one doesn't match up with
the much smaller gray connector with pigtail supplied to me. I even took
apart half of the dashboard and couldn't find it! For laughs I looked
behind the glove box as well. No go. Does anyone know where the gray
connector for the electronic brake control is?  Please tell me as soon a
possible. Thank you in advance.

P.S. one more bit of information: The sheet I have references a "2001
Explorer/Mountaineer." My is a 2002, although it's an early build and I'm
pretty sure it was built in 2001. The picture does look just like my
dash. Could it be I was supplied the wrong connector/pigtail and sheet
and that the correct pigtail connects to the big green connector?