Smartlock consists of 5 matching components : the smartlock
control module, the electronic ignition lock assembly, the
keypads, the dash warning light ("jewel") and the boot/tailgate
release lock.  Did you fit the matching set of all of these? It
also interfaces with the EEC V engine controller, the dome lamp
(must have a good globe and fuse), the engine ignition start
system, the central locking system and the hazard lamps. Are all
these components correctly connected and working?

PS sounds like a code 3 =- wrong data received. Have you
initiated the system by putting it in the learn mode?  Should
like not. Leave off for 30 minutes then:

a) Turn off all accessories.
b) Turn ignition to run position.
c)It will flash error code three again. Leave it run position
flashing away for 30 minutes and after 30 minutes the smartlock
module will download the codes and thew arming light will go
out.
d) After the warning light has gone off turn ignition switch to
off for 60 seconds or until the warning light displays the armed
flashing mode.
e) Remove key insert key and try to start car.

Big Brother ??  lol?

Hi there !

You are all so superb and i wished you all lived next door so we could be
car buddies lol !

Aussie Blu yoru a gem honey, and thank you. I followed yoru advice and now
whoola my car works like a GEM!

I went to the shops and locked my doors too with the remote i felt on top of
the world!

lol

Thanks :-) Rachael xxxxxxxx