Roy;
E-mail me with ''Ranger transmission' as subject line
G
> Thank you very much,
>
[quoted text clipped - 16 lines]
> | modulator
> | > | was put in it
Got it to the tranny shop.1st test drive (me driving) the tech noticed the
slipping, but wanted boss to check it out. 2nd drive with boss, started off with
the slipping, then the reams of white smoke and rough engine, rattling etc. He
thought the same as me, head gasket, when this happened back in the beginning of
this ordeal. Said it was virtually impossible for 2 modulators to go within a
tank of gas. So he pulled into the mechanic he knew to get a second opinion.
They popped the hood, pulled the vacuum line, smoke stopped and engine levelled
out.
Turns out the 1st garage dropped the little pin the modulator valve moves, this
in turn, was causing the diaphragm to blow.
They had a pin on hand, installed it with a new modulator and more fluid.
So 3 modulator valves and partial fluid changes later, I've still got a hard
shift up and down that I guess I'll have to live with. Carrying a lighter load
in my wallet doesn't seem to make any difference.
Do you think tinkering with the adjustment screw on the modulator valve might
help?
Thank you for all the help.

Signature
Roy
rem NADA to reply
| Thank you very much,
|
[quoted text clipped - 16 lines]
|| modulator
|| > | was put in it
TranSurgeon - 10 Sep 2005 19:37 GMT
> Do you think tinkering with the adjustment screw on the modulator valve might
> help?
refresh my memory on truck, engine, trans type
Roy Brown - 10 Sep 2005 21:34 GMT
| > Do you think tinkering with the adjustment screw on the modulator valve
| might
| > help?
|
| refresh my memory on truck, engine, trans type
94 Ranger 4X4 4.0 litre, A4LD

Signature
Roy
rem NADA to reply
TranSurgeon - 11 Sep 2005 00:29 GMT
OK
line pressure is controlled by modulator
shift timing is controlled by throttle cable
if the shifts are 'on time', leave the cable alone
if the shifts are 'too hard', first check for good vacuum at the modulator
it should track intake vacuum
if it does, then , yes, turn the adjustment screw 'out' (CCW) to 'soften'
the shifts; this will also make them a bit earlier
'in' (CW) to firm them up; this will make them a bit later
if the shifts are too early or late, adjust the throttle cable a notch at a
time one way or the other till they're where you want 'em
> | > Do you think tinkering with the adjustment screw on the modulator valve
> | might
[quoted text clipped - 3 lines]
>
> 94 Ranger 4X4 4.0 litre, A4LD
Roy Brown - 11 Sep 2005 04:34 GMT
Thank you,
I'll pull out the service manual to determine the right shift points and vacuum
levels before trying anything.

Signature
Roy
rem NADA to reply
| OK
|
[quoted text clipped - 24 lines]
| >
| > 94 Ranger 4X4 4.0 litre, A4LD