If you're talking about BeltMinder, this is it:
1. Turn the ignition switch to the RUN (or ON) position. (DO NOT

START THE ENGINE)

2. Wait until the safety belt warning light turns off. (Approximately 1

minute)

. Step 3 must be completed within 60 seconds after the safety belt

warning light turns off.

3. At a moderate speed, buckle then unbuckle the safety belt 9 times,

ending with the safety belt in the unbuckled state.

. After Step 3 is complete, the safety belt warning light will be turned

on for 3 seconds.

. If Step 4 does not occur within 10 seconds at the end of Step 3,

Beltminder will automatically exit programming mode without

changing its enable status.

4. Within 10 seconds of the light turning on, at a moderate speed, buckle

then unbuckle the safety belt.

. This will disable the BeltMinder feature if it is currently enabled. As

confirmation, the safety belt warning light will flash 4 times per

second for 3 seconds.

. This will enable the BeltMinder feature if it is currently disabled. As

confirmation, the safety belt warning light will flash 4 times per

second for 3 seconds, followed by 3 seconds with the light off, then

followed by the safety belt warning light flashing 4 times per second

for 3 seconds again.

5. After receiving confirmation, the deactivation/activation procedure is

complete.

SC Tom