On the way to the water pump

Thread view:

Enable EMail Alerts

Start New Thread

Thread rating:

Bill Schwab - 05 Nov 2007 20:27 GMT

Hello all,

Any tricks to disconnecting the misfire sensor connector? The
alternator is seriously in my way to get at it. Funny the shop manual
has neglected to show the latter - no doubt for clarity ;)

Anyway, the wiring harness will be in my way unless I detach it, or
perhaps the unit to which it connects. Suggestions/cautions would be
appreciated.

Thanks,

Bill

Reply to this Message

adambomb - 05 Nov 2007 23:45 GMT

> Any tricks to disconnecting the misfire sensor connector? The
> alternator is seriously in my way to get at it. Funny the shop manual
> has neglected to show the latter - no doubt for clarity ;)

Can't you just remove the alternator?

On my Ranger I had to at least move the A/C compressor out of the way.
I believe I was able to keep the alternator installed, but obviously
it's a completely different engine, and my point is that you may have to
move some of the accessories out of the way or remove them altogether.

Sorry I haven't been able to offer much help specific to your vehicle -
only what I know from doing the same work on another truck.

Reply to this Message

Bill Schwab - 06 Nov 2007 00:52 GMT

Adam,

>> Any tricks to disconnecting the misfire sensor connector? The
>> alternator is seriously in my way to get at it. Funny the shop manual
>> has neglected to show the latter - no doubt for clarity ;)
>
> Can't you just remove the alternator?

I thought about that, but it would not fully solve the problem, as the
connector/sensor still has to be removed to allow the wiring harness to
"let go" of the water pump. BTW, connector is off and the pump is now
"loose" but it appears that I have to remove the thermostat cover to
remove it. Even if I could do this with the thermostat in place, I
would hate to think of positioning it with the gasket and sealant
sticking to everything as I fumble my way past the thermostat. Note
that I replaced the thermostat not all that long ago, so I had planned
not to mess with it. No big deal, I can use the practice.

> On my Ranger I had to at least move the A/C compressor out of the way.
> I believe I was able to keep the alternator installed, but obviously
[quoted text clipped - 3 lines]
> Sorry I haven't been able to offer much help specific to your vehicle -
> only what I know from doing the same work on another truck.

That's ok; I appreciate the input. You are indirectly reinforcing some
of the other improvising I have done.

About the sensor, I talked to a few people and heard words like
screwdriver, pry and pull. On placing a jeweler's screwdriver in the
connector, I heard a click, and the connector was released. It dropped
a small plastic tab, which looks like a solid rectangle connected to a
slightly larger rectangle with a rectangular hole in it. From what I
can see, it is not broken, so could it be intended to be pushed in place
after the connector is inserted???

Bill

Reply to this Message