No Vacuum in EGR valve #16 hose

Thread view:

Enable EMail Alerts

Start New Thread

Thread rating:

Wavy - 29 Nov 2005 04:16 GMT

Hi All....

I have a little problem with my 1993 Honda Accord EGR system. The car
has 171K miles. The Engine runs fine at idle except for a slight,
inconsistant miss. Then the car has a slight hesitiation at about
1500-1800 RPM. Other than that, the car runs fine.

I checked the hose (#16) that goes to the EGR value and I determined
that it has NO vacuum in it (at idle or above 2000RPM).

What would cause NO vacuum to the line to the EGR valve?

A previous post said it might be the EGR solenoid.

How can I tell if the EGR solenoid is faulty?

I will admit to knowing very little about Hondas, but I really want to
learn.

Can someone please offer me advice to fix this problem?

Hondas are great cars and I would like to keep this one running for a
long time :-)

Reply to this Message

jim beam - 29 Nov 2005 04:36 GMT

> Hi All....
>
[quoted text clipped - 19 lines]
> Hondas are great cars and I would like to keep this one running for a
> long time :-)

you need to check the manual to be sure about this, but i don't think
there should be vacuum on that line all the time - only when the ecu
considers the load appropriate. besides, the actuators for that stuff
are /very/ reliable. first likelihood is that the egr valve is getting
clogged. take it off & clean it up. use a wooden spatula to remove the
gunk from the moving plug contraption, not metal - avoids scraping & gas
leakage. and the gasket will likely fall apart on removal of the egr
assembly, so buy a replacement before you start.

Reply to this Message

Wavy - 29 Nov 2005 23:26 GMT

Thanks for the reply Jim. Do I just have to clean the EGR valve?
Or, do I also have to clean the EGR passages under the brass plugs?
Also, if I have to clean the EGT passages, how do you take out the
plugs?? There is no way to grip them in order to take them out.
Seems like the only way to remove them is to drill them out. Am I
correct??

Thanks again!!!

Reply to this Message

jim beam - 30 Nov 2005 02:29 GMT

> Thanks for the reply Jim. Do I just have to clean the EGR valve?
> Or, do I also have to clean the EGR passages under the brass plugs?
[quoted text clipped - 4 lines]
>
> Thanks again!!!

try the valve first. if that's insufficient, do the plugs/passages.
google this group for a great pdf on the [small] drill/screw/slide
hammer technique for plug removal. DO NOT try to drill the whole plug
in one go - unless you have a source of bigger plugs.

Reply to this Message

Misterbeets - 30 Nov 2005 02:13 GMT

Idle problems would be caused by an open EGR, either one that is
clogged or getting vacuum at all times.

Reply to this Message