Does a stock P14 support VTEC

Thread view:

Enable EMail Alerts

Start New Thread

Thread rating:

rmiller - 31 Jan 2008 15:52 GMT

--------------------------------------------------------------------------------

I have replaced my H23A with a F22B1 and am wondering about the ECU.
Some sites say just to run the VTEC solenoid to the ECU, but I'm
wondering if the ECU already supports VTEC or do I need a different
ECU?

Reply to this Message

jim beam - 01 Feb 2008 03:50 GMT

> --------------------------------------------------------------------------------
>
> I have replaced my H23A with a F22B1 and am wondering about the ECU.
> Some sites say just to run the VTEC solenoid to the ECU, but I'm
> wondering if the ECU already supports VTEC or do I need a different
> ECU?

different ecu.

1. it's mapped different to take maximum advantage of the different cam.
2. the vtec has an output driver for the solenoid - the other doesn't.

for 2, you can switch it with a rev-activated switch instead, but the
ecu is the best way to go.

Reply to this Message

rmiller - 01 Feb 2008 23:31 GMT

> > --------------------------------------------------------------------------------
>
[quoted text clipped - 10 lines]
> for 2, you can switch it with a rev-activated switch instead, but the
> ecu is the best way to go.

OK, so I'm off looking for a P0A ECU for the F22B1 which is an OBD1
ECU for the engine model. The engine itself was from a 97 Accord which
is OBD2, so I'm told.

If the P0A is OK to use, how about the following:

1) Injector diff's - something about sizes, impeadances ect..
2) Does the OBD1 P0A ECU need to have the VTEC Oil Pressure sensor?
There wasn't one on the car before, but then again, the ECU for that
year was OBD2.

thanx for you help.

RJ

Reply to this Message