 |
 | Home | Contact Us | FAQ | Search & Site Map | Link to Us |
 | Sign In | Join | Other 45 Sites in Network |
Car Forum / Hyundai Cars / March 2006Door Adjustment---2006 Sonata
I just noticed my driver's side door stands out almost 1/16" from the B post. Looking at the passenger side, it's dead flush, as are both rear doors. I looked at the "U" shaped latch located on the post, and there appears to be no adjustment. A casual look at the latch in the door revealed no obvious adjustment either. How would the door be adjusted? I would rather do this myself, as I can afford to be careful, and take as long as necessary to avoid scratching the paint. The reason for wanting to pull the door in is not vanity. It doesn't show at all without using a straight edge. The reason is, I have a slight wind noise in the gasket at the top of the door, above the outside mirror. Thanks,,,  SignatureBob > I just noticed my driver's side door stands out almost 1/16" from the B > post. Looking at the passenger side, it's dead flush, as are both rear [quoted text clipped - 11 lines] > all without using a straight edge. The reason is, I have a slight wind > noise in the gasket at the top of the door, above the outside mirror. Bob: Try one of two things - and don't think of this as some sort of cob job effort. This is how it's done. 1) Open the door and stand between the open door and the car. Grab the top rear of the door and hold the bottom rear of the door against your leg. Pull down hard on the top rear. It will take some effort. Close the door and check the fit. Try it again if necessary. 2) Open the door full wide and place a block of wood between the body and the door, just above the lower hinge. Carefully close the door against the block of wood until the wood is pinched in place. Give it a bit more of a push to tweak the door and check the fit. Signature-Mike- mmarlowREMOVE@alltel.net Look at how the door fits at the top and bottom as well as the middle along the B-pillar. Look at how the door fits along the top and bottom edges. If it's simply sitting out at the B-pillar (from top to bottom), then you may simply be able to adjust the striker in. To do this, loosen the striker retaining bolts and see if you can slide it inward. If not, then you'll need to use some motivating force (large hammer) to force the striker inward. But if the door is out at the just the top or just the bottom, you'll need to use a method like Mike described. >Look at how the door fits at the top and bottom as well as the middle >along [quoted text clipped - 8 lines] >need >to use a method like Mike described. Thanks guys. I'll give it a shot. One worries about the window. I don't want to make the window hard to roll up or get scratched by the track. SignatureBob > >Look at how the door fits at the top and bottom as well as the middle > >along [quoted text clipped - 13 lines] > One worries about the window. I don't want to make the window hard to roll > up or get scratched by the track. You won't. You're not pulling the door that far and you're really only working the top part of the door. Don't get Herculean with the job - take it easy. Pull a bit, check it. Pull a bit, check it. Curse a bit. Pull a bit, check it. Curse again. Pull back the other way... Signature-Mike- mmarlowREMOVE@alltel.net |
Reply to this Message |
 Sign In
 Join
 My Latest Posts My Monitored Threads My Blog My Photo Gallery My Profile My Homepage Start New Thread Enable EMail Alerts Rate this Thread
|
©2008 Advenet LLC Privacy Policy - Terms of Use
This website includes both content owned or controlled by Advenet as well as content owned or controlled by third parties.