What a bag of shite!

I decided a couple of months ago i wasnt going to buy any more britpart
stuff - but I bought these last year as they were all i could get at the
time.

Around 12 months ago i replaced pretty much all the brakes on the 2A,
but was unable to get them adjusted such that it didnt pull and
eventually i ran out of tuits and parked the landy up.

I decided to finish the job today - and found that the problem was down
to the shitty britpart brake adjusters i had fitted.
The old ones i removed because they were worn fitted the snail onto the
shaft using a keyed hole to keep it in place (still got bits of them
knocking about in the shed).

The britpart ones use a round hole in the snail and a splined section on
the end of the shaft - the idea being that they are an interference fit.
Unfortunately they seem to be made to such a shitty tolerance that they
dont fit tightly - and i could only tighten the adjuster up so far
before the snail started spinning on the shaft - hence my difficulty in
adjusting the brakes.

How can they keep making this crap? Its not like it even did any miles
before breaking!

Sorry, i just feel the urge to rant! :)

Dont buy britpart stuff! - it never works!