Mine is mounted on that plate.  The height of the cushioned top is fine
for me.  Any particular reason for wanting it lower?

(My cubby box is from Exmoor Trim if that helps)

Happy New Year

Peter

I installed one of those secure ones with separate stereo compartment in my
90.
Much better than a centre seat in my opinion.
I left the plate and bolted to it an H shaped frame made up from 2" box
section metal.
It looks easy enough to make,But i bought mine from scorpion racing along
with the cubby.
The good thing doing this is it leaves a small gap between the plate and
cubby so wiring the stereo is also easy.

I once fitted a home made one to a series 11A, folded up a piece of
Birmabright into a box with no lid, the four sides had an outward fold on
the top, this was pop-riveted to the underside of the middle seatbox, then
the original lid goes on, padlock on the turnkey & it's secure. Never rusted
or got grubby inside as it was non-removable. The PTO dog clutch underneath
made the cubby quite small but still very useful & useable. Took about an
hour to make, bending the metal over a piece of scrap angle iron.

Karen

Hi

I put strips of Velcro on the batons and then stuck some to the plate
and velcro'd it in place. This way I can very easily remove it.

Thanks
Phil