Home | Contact Us | FAQ | Search & Site Map | Link to Us
Sign In | Join | Other 45 Sites in Network
HomeAnnouncements
Discussion Groups
By Brand
BMWChevroletDodgeFordGMHondaLexusMercedes-BenzNissanPeugeotToyotaVolkswagenOther Brands
By Topic
4x4 CarsRVsDrivingMaintenance & RepairCar AudioCollectible Cars
Country Specific
Australian ForumsUK Forums
ArticlesAuto InsuranceBuyingCars & TechnologyMaintenanceMiscellaneousSafety
DMV Resources
Related Topics
MotorcyclesBoatsMore Topics ...

Car Forum / Mercedes-Benz Cars / June 2005

Tip: Looking for answers? Try searching our database.

CLK Question

Thread view: 
Enable EMail Alerts  Start New Thread
Thread rating: 
John Lovin - 27 Jun 2005 14:16 GMT
My wife's Cabriolet CLK wouldn't start this morning.  She said she spilled a
"little" diet Coke in the gear shift area and thought that may be the
problem, so when it dried out, it will start now but will not go into gear.
I've wiggled the steering wheel (it's not locked up) and have the brake
on...any ideas why the vehicle will start but not go out of park?

Thanks in advance,

John Lovin
jalovin@charter.net
Kenneth P. Stox - 27 Jun 2005 15:51 GMT
OMG!!! The Pepsi Syndrome!!!
Lee - 27 Jun 2005 22:33 GMT
Err. Going out on a limb here, but do you think it could have anything to do
with the Coke your wife poured into the Gear Selector Module?
The fix is simple. Just have a new Selector Module fitted.
Should only cost a few hundred £/$.

> My wife's Cabriolet CLK wouldn't start this morning.  She said she spilled
> a "little" diet Coke in the gear shift area and thought that may be the
[quoted text clipped - 6 lines]
> John Lovin
> jalovin@charter.net
Vlad - 27 Jun 2005 23:06 GMT
>Err. Going out on a limb here, but do you think it could have anything to do
>with the Coke your wife poured into the Gear Selector Module?
>The fix is simple. Just have a new Selector Module fitted.
>Should only cost a few hundred £/$.

Back on the sugar .
Except for rare exception, like hard drives, most electronic boards,
switches, etc. can be cleaned by the use of the proper cleaning fluid.
Of  course it is much easier and profitable (for the dealer) to
replace the unit.
There is no way I would pay for a new unit.

>> My wife's Cabriolet CLK wouldn't start this morning.  She said she spilled
>> a "little" diet Coke in the gear shift area and thought that may be the
[quoted text clipped - 6 lines]
>> John Lovin
>> jalovin@charter.net
M. Davis - 28 Jun 2005 01:01 GMT
Coke  also contains phosphoric acid, the active ingredient in Naval
Jelly, a very effective rust remover.  It is  corrosive.  A staple of
elementary school science fair projects is to dissolve something
durable (teeth, bones, nails, etc.) in Coke (Pepsi, etc.).  Keep it
away from your electronics.
Marky - 28 Jun 2005 10:32 GMT
Could try tipping some water down the same place...
the water should dissolve the sticky mess left by the coke.

Or it's a matter of getting out the screwdriver...
Vlad - 27 Jun 2005 22:55 GMT
>My wife's Cabriolet CLK wouldn't start this morning.  She said she spilled a
>"little" diet Coke in the gear shift area and thought that may be the
[quoted text clipped - 6 lines]
>John Lovin
>jalovin@charter.net

I have waited for a more intelligent answer to your question. Since
nobody replied, here is my opinion.

Soft drinks contain sugar that stays on the surface once the liquid
dries.
The reliability of electric contacts (if any) may become an issue.
Sugar is not a lubricant either.
You may be able to tell if the problem is electrical or mechanical
cp - 28 Jun 2005 02:12 GMT
> I have waited for a more intelligent answer to your question. Since
> nobody replied, here is my opinion.
[quoted text clipped - 4 lines]
> Sugar is not a lubricant either.
> You may be able to tell if the problem is electrical or mechanical

Perhaps a bath in pure alcohol would do the trick, it would evaporate after
Vlad - 28 Jun 2005 14:38 GMT
>> I have waited for a more intelligent answer to your question. Since
>> nobody replied, here is my opinion.
[quoted text clipped - 6 lines]
>
>Perhaps a bath in pure alcohol would do the trick, it would evaporate after

Tektronix, at one time the largest manufacturer of oscilloscopes, had
a large container, very much like a big washing machine, used to clean
test equipment. A series of jets would spray the units that would come
out looking like new.
I don't know what liquid they used but I can make an attempt to find
out.
I have used an ordinary washing machine to clean a crappy Dumont
scope.
It cleaned so well that the graphite used inside of the potentiometers
also disappeared.
Tektronix used sealed potentiometers.

Vlad
cp - 29 Jun 2005 05:30 GMT
> It cleaned so well that the graphite used inside of the potentiometers
> also disappeared.

:-))))

> Tektronix used sealed potentiometers.

I hope it's available on eBay! :-)

cp
Vlad - 28 Jun 2005 14:54 GMT
The problem may not be related to the "little" diet Coke at all. Just
coincidence.
Vlad

>My wife's Cabriolet CLK wouldn't start this morning.  She said she spilled a
>"little" diet Coke in the gear shift area and thought that may be the
[quoted text clipped - 6 lines]
>John Lovin
>jalovin@charter.net
 
Sign In
Join
My Latest Posts
My Monitored Threads
My Blog
My Photo Gallery
My Profile
My Homepage

Start New Thread
Enable EMail Alerts
Rate this Thread



©2009 Advenet LLC   Privacy Policy - Terms of Use
This website includes both content owned or controlled by Advenet as well as content owned or controlled by third parties.