84 500 sel rear seat removal

Thread view:

Enable EMail Alerts

Start New Thread

Thread rating:

guzzi - 10 Apr 2006 06:08 GMT

Can anyone give me the procedure for removing the back seat, the seat has
power adjustment and heating.
I need access to the fuel tank to check the fuel level sending unit....Thanks

Reply to this Message

Paul - 10 Apr 2006 12:32 GMT

At the lower front of the bottom cushion there are 2 bolts with nuts, one on
each side. Move the seat forward just a little, and remove these two bolts.
Slide the seat cushion forward a few inches. Disconnect the seat heater
wires. Remove the cushion from the car. Below the rear cushion there is a
bolt on each side that holds the cushion in. Remove these two bolts,
disconnect the heater wires, lift the cushion stright up and remove from
car. You should see the sending unit.
Paul
84 500SEL
91 300D

> Can anyone give me the procedure for removing the back seat, the seat has
> power adjustment and heating.
> I need access to the fuel tank to check the fuel level sending
> unit....Thanks

Reply to this Message

guzzi - 13 Apr 2006 03:34 GMT

>At the lower front of the bottom cushion there are 2 bolts with nuts, one on
>each side. Move the seat forward just a little, and remove these two bolts.
[quoted text clipped - 10 lines]
>> I need access to the fuel tank to check the fuel level sending
>> unit....Thanks

Paul, it's easy if you know what your doing. Thanks for the instructions..
Guzzi

Reply to this Message

Roland Franzius - 10 Apr 2006 14:52 GMT

guzzi via CarKB.com schrieb:

> Can anyone give me the procedure for removing the back seat, the seat has
> power adjustment and heating.
> I need access to the fuel tank to check the fuel level sending unit....Thanks

In my 123 I think it was directly under the first aid box. No need to
remove seats.

Signature

Roland Franzius

Reply to this Message