How to Re-Set Sunroof

Thread view:

Enable EMail Alerts

Start New Thread

Thread rating:

Nota Clu - 13 Aug 2006 15:56 GMT

Opens fine, but stops when closing and re-opens.
2005 C230 Sedan
TIA

Reply to this Message

Karl - 13 Aug 2006 16:18 GMT

Where are you? How many miles on the car?

There is a bulletin on this problem. The overhead control unit [dome light looses CAN signal] and
may need to be replaced.

> Opens fine, but stops when closing and re-opens.
> 2005 C230 Sedan
> TIA

Reply to this Message

WRENCHER - 13 Aug 2006 20:06 GMT

Nota clu: have the sunroof in the closed position. push up on the ocp
switch and then
push down and hold for 5 seconds//

Reply to this Message

Nota Clu - 14 Aug 2006 12:56 GMT

Pardon my ignorance, but what is a ocp switch?
I will try the open switch & if that doesn't work will take it to the
dealer.
Also, the shift knob has come apart.

> Nota clu: have the sunroof in the closed position. push up on the ocp
> switch and then
> push down and hold for 5 seconds//

Reply to this Message

WRENCHER - 13 Aug 2006 20:06 GMT

Nota clu: have the sunroof in the closed position. push up on the ocp
switch and then
push down and hold for 5 seconds//

Reply to this Message

Roland Franzius - 14 Aug 2006 13:23 GMT

Nota Clu schrieb:

> Opens fine, but stops when closing and re-opens.
> 2005 C230 Sedan
> TIA

You must reset the sensor. Open the sunroof completely by until it
clacks at the end. You must pull the knob after each stop. Then close
ist completely. Push again the knob it after each stop. Push the knob up
to the lift position and pull it down again. After this procedure the
roof should open and close automatically.

Found out by trial and error.

Signature

Roland Franzius

Reply to this Message

me - 14 Aug 2006 18:22 GMT

> Nota Clu schrieb:
>> Opens fine, but stops when closing and re-opens.
[quoted text clipped - 8 lines]
>
> Found out by trial and error.

It is in the manual too.

Reply to this Message

Roland Franzius - 15 Aug 2006 09:57 GMT

me schrieb:

>> Nota Clu schrieb:
>>> Opens fine, but stops when closing and re-opens.
[quoted text clipped - 9 lines]
>
> It is in the manual too.

Fine, but not in that of mine. Looked around for hours in that 4 books.

Signature

Roland Franzius

Reply to this Message