 |
 | Home | Contact Us | FAQ | Search & Site Map | Link to Us |
 | Sign In | Join | Other 45 Sites in Network |
Car Forum / MINI / April 2006Disc Brake Calipers Torque settings Info
I have just overhauled some MG calipers and referring to the workshop manual came across the following "Unless it is absolutely unavoidable the caliper should not be separated into two halves. In the event of separation becoming essential, the fluid cannel seal, clamping bolts.and lock plates must be renewed when reassembling. Only bolts supplied by BMC Service Ltd. may be used. On assembly these must be tightened with a torque wrench set at between 35.5 - 37 lb.ft 4.9-5.1kg m. Ensure that the caliper faces are clean and that the threaded bolt holes are thoroughly dry. Make certain that the new fluid channel seal is correctly located in the recessed face before assembling the caliper halves." This is most likely where, in the first paragraph, the "forbidden in the Haynes manual" comes from. Secondly the bolts are a extra high tensile and have 6 marks on the head - not the usual 3 as in high tensile marks - hence the higher torque settings. Hi Rob, did it say anything about the two halves being pressed together prior to the bolts being torqued up, I mentioned this a while ago, as I recall reading it somewhere, Fitzy >I have just overhauled some MG calipers and referring to the workshop >manual came across the following [quoted text clipped - 17 lines] > not the usual 3 as in high tensile marks - hence the higher torque > settings. > Hi Rob, > did it say anything about the two halves being pressed > together prior to the bolts being torqued up, > I mentioned this a while ago, as I recall reading it somewhere, > Fitzy I can't see why the press as the surfaces are flat and for sure its not going to make any difference. The most difficult bit would be to set the caliper up squarely under a press so pressure could be applied. I've always only cleaned the surfaces on a surface plate (or glass) with 400 wet and dry paper then placed the seal into the recess with some silicon fluid then tightened the bolts up. None have leaked. The information quoted is not mentioned in the Mini service manual at all and the calipers are virtually the same. rm >>I have just overhauled some MG calipers and referring to the workshop >>manual came across the following [quoted text clipped - 17 lines] >>not the usual 3 as in high tensile marks - hence the higher torque >>settings. The main thing is keeping the surfaces clean and getting the fluid seal fitted correctly. 35-37lb ft is quite low so you need to ensure that the threads are clean and not binding in any way so you get a correct torque reading. I would think getting hold of the bolts would be the most difficult part of the job. It is quite normal on other cars to split calipers and use a spacer when converting to ventilated discs, the spacer has a grove for the seals on both sides and you use 2 sets of seals, the kits come with new bolts as they need to be longer. > I have just overhauled some MG calipers and referring to the workshop > manual came across the following [quoted text clipped - 17 lines] > - not the usual 3 as in high tensile marks - hence the higher torque > settings. |
Reply to this Message |
 Sign In
 Join
 My Latest Posts My Monitored Threads My Blog My Photo Gallery My Profile My Homepage Start New Thread Enable EMail Alerts Rate this Thread
|
©2008 Advenet LLC Privacy Policy - Terms of Use
This website includes both content owned or controlled by Advenet as well as content owned or controlled by third parties.