Maxima has a terrible shake at 50 and gets worse the faster you go.
Feels like the front end is going to fall off!! Shakes worse if I turn
wheel to left as Im going 50mph and up. Cv joints are fine and struts
dont bounce either?? Sounds like metal hitting metal very quickly. Ball
joints? Thanks Nel:)
Dan - 26 Jul 2004 03:11 GMT
Nelson :) wrote:
> Maxima has a terrible shake at 50 and gets worse the faster you go.
> Feels like the front end is going to fall off!! Shakes worse if I turn
> wheel to left as Im going 50mph and up. Cv joints are fine and struts
> dont bounce either?? Sounds like metal hitting metal very quickly. Ball
> joints? Thanks Nel:)
wheel bearing...
David Geesaman - 26 Jul 2004 12:18 GMT
And make sure your lugnuts are tight.
PS I wouldn't drive it if the car is that rough.
Dave
> Nelson :) wrote:
> > Maxima has a terrible shake at 50 and gets worse the faster you go.
[quoted text clipped - 4 lines]
>
> wheel bearing...
David Efflandt - 27 Jul 2004 21:03 GMT
> Nelson :) wrote:
>> Maxima has a terrible shake at 50 and gets worse the faster you go.
[quoted text clipped - 4 lines]
>
> wheel bearing...
That would be my guess. I had one go bad a long time ago (rt front of 95
SE). I tried 3 times to get my dealer to look at it and they never did
anything, even when I told them that a right front wheel was loose when
jacked up. I finally took it to an independent garage, and by then the
bearing had eaten into the axle and required replacement of hub assembly.
I was also told at one time that one of my lower control arm bushings was
migrating (apparently squishing out of place). That was not noticeable in
driving, but I had lower control arms replaced while replacing struts.

Signature
David Efflandt - All spam ignored http://www.de-srv.com/
E. Meyer - 26 Jul 2004 17:08 GMT
On 7/25/04 7:04 PM, in article
4677-41045896-395@storefull-3332.bay.webtv.net, "Nelson :)"
<porshapower1@webtv.net> wrote:
> Maxima has a terrible shake at 50 and gets worse the faster you go.
> Feels like the front end is going to fall off!! Shakes worse if I turn
> wheel to left as Im going 50mph and up. Cv joints are fine and struts
> dont bounce either?? Sounds like metal hitting metal very quickly. Ball
> joints? Thanks Nel:)
Check the upper strut mounts. Position yourself where you can see the strut
top bolt and bounce the car. If there is any movement at all, the mount is
bad.
john smith - 27 Jul 2004 01:23 GMT
Check the inner tie rod ends and the lower ball joints.
Nelson :) wrote:
> Maxima has a terrible shake at 50 and gets worse the faster you go.
> Feels like the front end is going to fall off!! Shakes worse if I turn
> wheel to left as Im going 50mph and up. Cv joints are fine and struts
> dont bounce either?? Sounds like metal hitting metal very quickly. Ball
> joints? Thanks Nel:)