vibration damper

Thread view:

Enable EMail Alerts

Start New Thread

Thread rating:

Lane Wyman - 26 Sep 2005 07:03 GMT

Can anyone recommend the easiest way to remove it on a 90 pathfinder?

Reply to this Message

Steve T - 26 Sep 2005 08:08 GMT

> Can anyone recommend the easiest way to remove it on a 90 pathfinder?

A balancer puller.

Signature

Steve

http://www.atlantaracing.com

Reply to this Message

Lane Wyman - 26 Sep 2005 16:02 GMT

i have that, but i have to get the bolt out. I tried thru the starter
hole, but not enough room to get in there.

>> Can anyone recommend the easiest way to remove it on a 90 pathfinder?
>
>A balancer puller.

Reply to this Message

Shawn - 27 Sep 2005 03:15 GMT

if worse came to worsre, you may have to unbolt the motor mounts and hoist
out the engine a little bit to get clearance to the vibration damper.

>i have that, but i have to get the bolt out. I tried thru the starter
> hole, but not enough room to get in there.
>
>>> Can anyone recommend the easiest way to remove it on a 90 pathfinder?
>>
>>A balancer puller.

Reply to this Message

Lane Wyman - 27 Sep 2005 04:54 GMT

Got it. Thanks.
Finally got something to block the teeth on the flywheel thru the
starter hole.

>if worse came to worsre, you may have to unbolt the motor mounts and hoist
>out the engine a little bit to get clearance to the vibration damper.
[quoted text clipped - 5 lines]
>>>
>>>A balancer puller.

Reply to this Message