86 nissan hardbdy z24 need help

Thread view:

Enable EMail Alerts

Start New Thread

Thread rating:

Chad - 12 Apr 2006 03:02 GMT

i have an 86 nissan with a z24 in it. I was driving on the highway and it
just seemed to stop going. I had it towed home and replaced the fuel
filter. It runs now, but if i press the gas pedal down, it just seems to
stop going. it idles fine, but i cant drive it. Here is what i fixed.

replaced the fuel filter,air cleaner,throttle position sensor,fuel
injectors, fuel pump. Still same thing. Could it be my computer? as i
replaced them, i tried running the engine. It has never changed? HELP

Chad

Reply to this Message

Randy - 12 Apr 2006 03:22 GMT

plugged or restricted exhaust?????

> i have an 86 nissan with a z24 in it. I was driving on the highway and it
> just seemed to stop going. I had it towed home and replaced the fuel
[quoted text clipped - 6 lines]
>
> Chad

Reply to this Message

Chad - 12 Apr 2006 04:30 GMT

not that i know of ill look in to it

> plugged or restricted exhaust?????
>
[quoted text clipped - 8 lines]
>>
>> Chad

Reply to this Message

Steve T - 12 Apr 2006 07:03 GMT

> i have an 86 nissan with a z24 in it. I was driving on the highway and it
> just seemed to stop going. I had it towed home and replaced the fuel
[quoted text clipped - 4 lines]
> injectors, fuel pump. Still same thing. Could it be my computer? as i
> replaced them, i tried running the engine. It has never changed? HELP

MAS, it's in the side of the throttle body if I am thinking of the right
engine..

Signature

Steve

http://www.atlantaracing.com

Reply to this Message

jim - 12 Apr 2006 09:30 GMT

> i have an 86 nissan with a z24 in it. I was driving on the highway and it
> just seemed to stop going. I had it towed home and replaced the fuel
[quoted text clipped - 6 lines]
>
> Chad

Years ago i had a '69 Ford Zephyr which would not go over 30 mph.It
would get up to 30, then cut out. As it slowed it would power on again.
etc. It turned out to be the ignition coil heating due to a
short-circuit. So i replaced that and it never looked back. Perhaps
something else to look at...

Reply to this Message