93 Nissan 3300 v-6

Thread view:

Enable EMail Alerts

Start New Thread

Thread rating:

bakrobb - 10 May 2008 00:22 GMT

Can anybody help me?? I have a 93 nissan pick-up and the timing belt
went bad on it, I have installed a new one and the manual I have
showed timing marks on the oil pump housing which I can’t seem to
locate? I went by the lines on the belt and it is not running on all
6 cylinders. I pulled the air plenum off and held my hand over the
holes while cranking and #5 and 6 are sucking and then blowing back
up, is it possible I might be off 1 tooth on the crank timing gear??

Thanks

Signature

Posted at author's request, using moderated http://www.AutoBoardz.com interface
Thread archive: http://www.AutoBoardz.com/93-Nissan-3300-ftopict247290.html

Reply to this Message

still just me - 10 May 2008 04:57 GMT

>Can anybody help me?? I have a 93 nissan pick-up and the timing belt
>went bad on it, I have installed a new one and the manual I have
[quoted text clipped - 5 lines]
>
>Thanks

WAG - I'm not familiar with that particular motor: Did your last belt
break? As I recall, Nissan V6's of that era bend things when the belt
snaps. Sounds like you might have bent valve shafts and some valves
stuck open.

It's also possible that you have the timing _way_ off.

Reply to this Message

AS - 11 May 2008 19:31 GMT

If only two cylinders are defective, chances are that the valves got
bent when the belt broke.

>>Can anybody help me?? I have a 93 nissan pick-up and the timing belt
>>went bad on it, I have installed a new one and the manual I have
[quoted text clipped - 12 lines]
>
> It's also possible that you have the timing _way_ off.

Reply to this Message