406 ecu not cooling

Thread view:

Enable EMail Alerts

Start New Thread

Thread rating:

ib - 15 Jun 2005 19:00 GMT

There's gas in the system (and I've bypassed the pressure sensors anyway)
but there's no volts to the compressor clutch, with the system set to cool.

What else could it be?

Thanks

Reply to this Message

ib - 16 Jun 2005 20:48 GMT

Also noticed, put the fan on auto, and sweep the demand temp from 14 to max,
fan stays at minimum speed- could this indicate that it's a control problem?
Maybe temp sensor not working, so ecu doesn't know what to do?

> There's gas in the system (and I've bypassed the pressure sensors anyway)
> but there's no volts to the compressor clutch, with the system set to
[quoted text clipped - 3 lines]
>
> Thanks

Reply to this Message

Marc - 16 Jun 2005 23:29 GMT

>Also noticed, put the fan on auto, and sweep the demand temp from 14 to max,
>fan stays at minimum speed- could this indicate that it's a control problem?
>Maybe temp sensor not working, so ecu doesn't know what to do?

i've posted this many times

look for faults in the relay's right in between the cooling fans, its
a triangularish box and you'll be likely to find the one on the
downside ( there is three) to have the leads rotten of, replace the
leads and go sit in your nice and cool 406 :-)

>> There's gas in the system (and I've bypassed the pressure sensors anyway)
>> but there's no volts to the compressor clutch, with the system set to
[quoted text clipped - 3 lines]
>>
>> Thanks

Reply to this Message