Hi,

It shouldn't be a problem. Remove the plastic plate which hides the cig.
lighter hole (should be in the ashtray), you'll find the wiring & connector
around here too (you'll need to remove the ashtray, but that's not a big
job).
I'm pretty sure it's the same job on a 106 than on a 205 - done that on my
'93 Junior.

HTH,
G.T
205 Diesel & turbo-Diesel : www.205d.com

It was 1995 when I did ours, so the details are a bit hazy :-)
All the wiring is in place (there is a connector behind the hole that
just plugs into the lighter), but as I remember you have to pull the big
bit of fascia plastic that surrounds the lighter hole (and radio, etc)
forward enough to fit the lighter behind it (the lighter is sandwiched
between that and the frame of the dashboard). It's not a difficult or
long job, but you need to undo a few screws to get that fascia either
fully removed or loose enough to be able to slide the lighter behind it.

Again, from memory, there are a couple of screws in the ashtray,
removing these you may have enough "give" in the fascia to do the job
(that was how I did ours, but be careful not to pull the plastic too
hard). To give you more space, you can pull off the ventilation fan
control knob and remove the screw under there, pull the ventilation
control knobs straight out, then the plate that they sit on (printed
with the blue/red temperature etc) will come off, then another couple of
screws beneath that let you pull the facia far enough forward to do the
job easily. The hardest part is pulling off the ventilation fan control
knob - I used a piece of card inside the jaws of some pliers to give me
the grip needed without damaging the plastic surface.

Matt
http://www.807faults.co.uk

Many thanks for the advice, I will visit local Peugeot dealer then give it a
go.
Colin