Phone installation / problem with Satnav

Thread view:

Enable EMail Alerts

Start New Thread

Thread rating:

gollycrush - 06 May 2006 19:37 GMT

Having installed a Phone kit in my 406 "03" the Satnav does not operate, on
screen display says "CD ROM Unreadable" or "CD Missing". on disconecting
the phone kit the display still shows the same errors Only when i
disconnect the battery for resetting does the satnav return to normal
operations and firstly show " Satnav system initializing." Hence the kit
is now disconnected, Any ideas would be much appreciated????????????

Reply to this Message

Dave G - 07 May 2006 13:04 GMT

Hi, I am not sure if the following will be of interest but I doubt if the
problem has anything to do with your phone kit. I have a 2003 406 with 104,
000 miles but without a phone. To date I am on my 3rd Satnav unit and they
have all displayed the error messages that you describe. All 3 units worked
ok for about 12 months then the messages start and become more frequent until
the unit dies. The current unit is in its early stages of failure.

Cleaning the cd and the laser helps for a time but the problem always returns
also letting the unit initialise before starting the engine helps. My local
"stealership" replaced the 1st unit in warranty but now wants £750 to replace
it again, I declined his "offer".

In my opinion this is an intermittent mechanical problem within the cd drive.

Dave G

>Having installed a Phone kit in my 406 "03" the Satnav does not operate, on
>screen display says "CD ROM Unreadable" or "CD Missing". on disconecting
>the phone kit the display still shows the same errors Only when i
>disconnect the battery for resetting does the satnav return to normal
>operations and firstly show " Satnav system initializing." Hence the kit
>is now disconnected, Any ideas would be much appreciated????????????

Reply to this Message

gollycrush - 10 May 2006 21:34 GMT

Thanks for your reply and information. Since posting my problem the unit
itself has indeed become more frequent in displaying the error messages.
initialising displays everytime now with the ignition activated and most
times now does not progress from there. when it does i cant change the
input destination and the display shows a spinning disc. Obviously as you
suggest with having three units there must be a common fault with the
units. are the units repairable do you know????????at the cost you mention
for replacement im hoping so. regds Neil

Reply to this Message

Dave G - 14 May 2006 11:42 GMT

Hi, This is exactly what happens to them. I have had no luck in finding a
repairer. The same thing happened to friend of mine and he got one from a
breaker for £75. It is very easy to change just needs a Torx TX30 screwdriver
which are available at Halfords. I think the dealer price is a rip off, I
could buy the best Tom Tom for half that.

Regards

Dave

>Thanks for your reply and information. Since posting my problem the unit
>itself has indeed become more frequent in displaying the error messages.
[quoted text clipped - 4 lines]
>units. are the units repairable do you know????????at the cost you mention
>for replacement im hoping so. regds Neil

Reply to this Message