roll bar

Thread view:

Enable EMail Alerts

Start New Thread

Thread rating:

Chris - 01 Jun 2006 19:06 GMT

HiGroup.
Dos anybody know the size of anti roll bar rubbers on a pu 405
on a k plate??or do i have to remove them and take them to get the
right ones.
thanks for any replys from chris

Reply to this Message

nigel - 01 Jun 2006 21:56 GMT

>HiGroup.
> Dos anybody know the size of anti roll bar rubbers on a pu 405
>on a k plate??or do i have to remove them and take them to get the
>right ones.
>thanks for any replys from chris

What you need to know is the size of the bar. From memory you have a
choice of 21,22 or23 mm (or is it 20,21 or 22). Whatever, you need to
measure the diameter of the bar. Easiest way is to get say a 22mm (or
21mm) open ended spanner and see how it fits at a convenient point on
the bar. If won't go on at all, you need next size up. If it is
obviosly too big then you need the size down.

Reply to this Message

Chris - 02 Jun 2006 22:23 GMT

> >HiGroup.
> > Dos anybody know the size of anti roll bar rubbers on a pu
[quoted text clipped - 8 lines]
> the bar. If won't go on at all, you need next size up. If it is
> obviosly too big then you need the size down.

I spent a couple of hours trying to find out which size they are then
in the end i got hold of a micromter well some thing like that and
found out they are 22mm.
so thanks for the reply nigel.from chris Addlestone Surrey

Reply to this Message