My 2000 Gran Prix GT with 3.8 L normally aspirated engine has a transmission
oil leak at the seal around the left half-axel shaft output.
Is it possible to replace this seal without pulling the transmission?
Ray
Ray - 21 Mar 2006 01:16 GMT
Just a bit of additional info, the transmission is a type 4T65E.
Ray
Scott Zabolotzky - 21 Mar 2006 16:00 GMT
If you ask this on the Drivetrain forum of http://www.clubgp.com/ you'll
get a definitive answer, but I'm pretty sure that yes, it can be
changed with the tranny still in the car. I seem to recall reading
about guys that have done it.
Scott
scrapir - 22 Mar 2006 01:35 GMT
Yes it can be changed without dropping the transmission. You will need to
take the lower ball joint nut off and then you can pull the spindle out
enough to take the axle out. Once you've done that you can get right at
the seal.