2000 Bonneville oil pressure too high

Thread view:

Enable EMail Alerts

Start New Thread

Thread rating:

DJ - 16 Feb 2007 01:10 GMT

On my 2000 Bonneville with 86K miles I recently noticed the oil pressure
gage pegging out at 120 psi. It stays there all the time when the
engine is running - idle or high rpms it's still the same. With the
engine off and ignition on it reads zero. Would this be the pressure
sender or some other cause? Engine runs fine otherwise. Thanks!

Reply to this Message

clare at snyder.on.ca - 16 Feb 2007 01:48 GMT

>On my 2000 Bonneville with 86K miles I recently noticed the oil pressure
>gage pegging out at 120 psi. It stays there all the time when the
>engine is running - idle or high rpms it's still the same. With the
>engine off and ignition on it reads zero. Would this be the pressure
>sender or some other cause? Engine runs fine otherwise. Thanks!

Most likely the guage sender- but DEFINITELY have it tested. ASAP.

Signature

Posted via a free Usenet account from http://www.teranews.com

Reply to this Message

DJ - 17 Feb 2007 18:01 GMT

>>On my 2000 Bonneville with 86K miles I recently noticed the oil pressure
>>gage pegging out at 120 psi. It stays there all the time when the
[quoted text clipped - 3 lines]
>
> Most likely the guage sender- but DEFINITELY have it tested. ASAP.

Thanks - I'll check it.

Reply to this Message

Micah - 16 Feb 2007 15:49 GMT

My first guess would be the sending unit but I would test it. It should
work with a resistance to grnd. If it is shorting directly to grnd your
gauge would read high. Check the dc voltage between pos 12 vdc from the
battery & the ground leg going to the gauge. (Check on sending unit) If this
reads approx 12 vdc the gauge should be reading correctly. Check with the
engine off and wires disconnected also, if it reads 12 vdc the sending unit
is bad. There are 2 legs on the sending unit as I recall. One should close
an interlock relay allowing the fuel pump to come on after they system build
6 psi or so. This leg should show 12 vdc after required pressure builds.
Make sure these 2 wires aren't shorted together. Also could have a blocked
filter not allowing a good flow and causing a 100% grnd on the sending unit.
If this is the case you should hear the lifters chattering. See if it takes
a sec for the pressure gauge to drop after stopping the engine. Try changing
the oil filter, & oil if dirty. This is my interpretation without having any
prints on electrical system. Hopefully this will help.

> On my 2000 Bonneville with 86K miles I recently noticed the oil pressure
> gage pegging out at 120 psi. It stays there all the time when the engine
> is running - idle or high rpms it's still the same. With the engine off
> and ignition on it reads zero. Would this be the pressure sender or some
> other cause? Engine runs fine otherwise. Thanks!

Reply to this Message

DJ - 17 Feb 2007 18:00 GMT

> My first guess would be the sending unit but I would test it. It should
> work with a resistance to grnd. If it is shorting directly to grnd your
[quoted text clipped - 17 lines]
>>and ignition on it reads zero. Would this be the pressure sender or some
>>other cause? Engine runs fine otherwise. Thanks!

Thanks - I'll check it out as you suggest. By blocked filter I assume
you mean the main engine oil filter? I have recently changed oil
(Castrol 5W30 synthetic) and filter so it should not be blocked. I do
tend to hear the lifters chatter a bit at cold startup which bothers me
- but I believe this was true before the gage started acting up.

Reply to this Message