97 trans sport side body molding removal?

Thread view:

Enable EMail Alerts

Start New Thread

Thread rating:

Jamffer - 30 May 2008 19:34 GMT

Do I need to take apart the interior to get off the lower side molding?
Probably or is it glued? Need to Bondo couple of rocker panel fender holes
in "97 trans sport.
Excuse this maybe lazy dumb question but I'm too cheap to buy a book.
Jamffer

Reply to this Message

Refinish King - 31 May 2008 10:12 GMT

Look at the bottom if it goes all the way to the rocker,

If it does, there are most likely some 7 MM screws, that hold it to the
rocker panel, then you'll have to either pull up or push down, slowly and
forcefully at the top.

One end of the clip has two spring like tabs, and the other end of the clip
in the lock.
Be careful not to break the clips, and as you push up or pull down. Pull
outward lightly also.

RK

> Do I need to take apart the interior to get off the lower side molding?
> Probably or is it glued? Need to Bondo couple of rocker panel fender
> holes
> in "97 trans sport.
> Excuse this maybe lazy dumb question but I'm too cheap to buy a book.
> Jamffer

Reply to this Message