crankshaft angle sensor

Thread view:

Enable EMail Alerts

Start New Thread

Thread rating:

Rollo - 11 Aug 2008 14:23 GMT

Are there any tricks or cautions that should be used to remove the
crankshaft angle sensor from a 1990 3.1L Pontiac? It is located on
the firewall side of the block and extends into the block about 2
inches. I have heard that they can break off or stick in the block.

Signature

Posted at author's request, using moderated http://www.AutoBoardz.com interface
Thread archive: http://www.AutoBoardz.com/crankshaft-angle-sensor-ftopict248426.html

Reply to this Message

Rollo - 11 Aug 2008 14:23 GMT

No need to reply. It was tough to get to but after spinning it a few
times it slid out

> Are there any tricks or cautions that should be used to remove
> the crankshaft angle sensor from a 1990 3.1L Pontiac? It is
> located on the firewall side of the block and extends into the
> block about 2 inches. I have heard that they can break off or
> stick in the block.

Reply to this Message