Home | Contact Us | FAQ | Search & Site Map | Link to Us
Sign In | Join | Other 45 Sites in Network
HomeAnnouncements
Discussion Groups
By Brand
BMWChevroletDodgeFordGMHondaLexusMercedes-BenzNissanPeugeotToyotaVolkswagenOther Brands
By Topic
4x4 CarsRVsDrivingMaintenance & RepairCar AudioCollectible Cars
Country Specific
Australian ForumsUK Forums
ArticlesAuto InsuranceBuyingCars & TechnologyMaintenanceMiscellaneousSafety
DMV Resources
Related Topics
MotorcyclesBoatsMore Topics ...

Car Forum / Driving, Maintenance, Tuning / RVs / May 2005

Tip: Looking for answers? Try searching our database.

Battery Connections etc

Thread view: 
Enable EMail Alerts  Start New Thread
Thread rating: 
Smeeky - 21 May 2005 16:12 GMT
Hi all, first of all I'm new at this and I hope you can help me in answering
some of my questions about our newly acquired Starcraft pop up.

When I went to check the battery I found the connections were not attached
and I'm not sure of the correct sequence.  I have three connectors; one red
(positive?), one white (negative?) and one green (unsure).  Can someone tell
me the correct connections to the battery?

Also I find I have a small leak in drain from the sink--while not easy to
get at I think with a little contortions I can reach it.  The pipe is PVC
and it appears the leak is where two pipes join. Any recommendations on the
best way plug the leak--I really don't want to take the piping apart and
re-do?

Thanks in advance--I'm sure I will have more questions as we get going with
this.

Smeeky
Rich256 - 21 May 2005 20:08 GMT
> Hi all, first of all I'm new at this and I hope you can help me in answering
> some of my questions about our newly acquired Starcraft pop up.
[quoted text clipped - 3 lines]
> (positive?), one white (negative?) and one green (unsure).  Can someone tell
> me the correct connections to the battery?

You are most likely correct on the red and white.  The green could be a lot
of things.  Do you have electric brakes?  Is there a break away switch on
the tongue?  Does the green wired go there?  If so it would connect to the
battery positive.

> Also I find I have a small leak in drain from the sink--while not easy to
> get at I think with a little contortions I can reach it.  The pipe is PVC
> and it appears the leak is where two pipes join. Any recommendations on the
> best way plug the leak--I really don't want to take the piping apart and
> re-do?

Probably a crack in the pipe.  I would buy some flexible high pressure 1/2
inch tubing, cut out the cracked area and use clamps to fasten in the
tubing.
Ferg - 26 May 2005 06:01 GMT
> > When I went to check the battery I found the connections were not attached
> > and I'm not sure of the correct sequence.  I have three connectors; one
[quoted text clipped - 7 lines]
> the tongue?  Does the green wired go there?  If so it would connect to the
> battery positive.
I have a Starcraft and it has three wires but they are of different
colors.  I have two that go to the positive and one that goes to the
negative.  One of the positive has a 20 amp fuse and the other has a 30
amp fuse.  The reason they are usually disconnected is that if you keep
the battery connected to the inverter the alarm will go off when the
battery is low.  I think this is the same alarm used to detect gas
leaks.  I usually just pull the fuses rather than disconnecting from
the battery.  When I forget, the alarm will go off after being parked
for a couple of weeks.  The neighbors don't especially like that noise
when they have to wait for me to get hom.

Hope this helps!

Ernie
Missouri

> > Also I find I have a small leak in drain from the sink--while not easy to
> > get at I think with a little contortions I can reach it.  The pipe is PVC
[quoted text clipped - 6 lines]
> inch tubing, cut out the cracked area and use clamps to fasten in the
> tubing.
Smeeky - 28 May 2005 13:02 GMT
Thanks, with fuse explanation I think we have the same type of connections.
>> > When I went to check the battery I found the connections were not
>> > attached
[quoted text clipped - 40 lines]
>> inch tubing, cut out the cracked area and use clamps to fasten in the
>> tubing.
 
Sign In
Join
My Latest Posts
My Monitored Threads
My Blog
My Photo Gallery
My Profile
My Homepage

Start New Thread
Enable EMail Alerts
Rate this Thread



©2008 Advenet LLC   Privacy Policy - Terms of Use
This website includes both content owned or controlled by Advenet as well as content owned or controlled by third parties.