How to treat rust inside the doors?

Thread view:

Enable EMail Alerts

Start New Thread

Thread rating:

Tim Ulrich - 19 Aug 2006 06:00 GMT

I'm looking for any suggestions on how to treat the rust inside the doors.
I have them pretty well stripped of all trim, glass and regulators. I've
been using POR-15 Metal Ready on the outside but I would like to do a good
job on the inside.

Thanks in advance,
Tim

Reply to this Message

So. Ga. Cruiser - 19 Aug 2006 13:13 GMT

I sprayed the Osmote stuff from NAPA inside the door, and then painted over
it with POR-15...

Dave Miller

Reply to this Message

Bill Glass - 20 Aug 2006 15:11 GMT

Back in 1987-89 POR-15 2 was all the rage. I painted as much of the inside
of the doors I could with POR-15, then topcoated with primer, and when all
was dry, spayed undercoatng inside all the doors. it served two purposes,
one its prevents water from attacking the metaal, and two it quiets down
road noise. The othe places that I sprayed undercoating was inside the door
hinges, and othe outer part of the cowl where the fender meets the car body.

BG

> I'm looking for any suggestions on how to treat the rust inside the doors.
> I have them pretty well stripped of all trim, glass and regulators. I've
[quoted text clipped - 10 lines]
> ----= East and West-Coast Server Farms - Total Privacy via Encryption
> =----

Reply to this Message

Tim Ulrich - 21 Aug 2006 02:57 GMT

Bill,

How did you spray inside the door and get good coverage?

> Back in 1987-89 POR-15 2 was all the rage. I painted as much of the inside
> of the doors I could with POR-15, then topcoated with primer, and when all
[quoted text clipped - 19 lines]
> > ----= East and West-Coast Server Farms - Total Privacy via Encryption
> > =----

Reply to this Message